DisplayMaker Legacy 72S and 72SR - User Manual

1-22 Unpacking and Assembly
Connecting to Power See Appendix A, Technical Specifications, or refer to the Site
Preparation Guide, for detailed power requirements. Consult a
qualified electrician if you have any doubt as to how the circuits
in your facility can accommodate the printer and print server.
WARNING
WITH THE POWER SWITCH IN THE OFF POSITION,
POWER MAY STILL BE SUPPLIED TO THE PRINTER
COMPONENTS. To cut power completely from the
printer, you must unplug the power cords from the
power outlets.
WARNUNG
WENN DER NETZSCHALTER IN OFF POSITION
STEHT, WIRD DEN KOMPONENTEN TROTZDEM
STROM ZUGEFÜHRT. Um den Drucker komplett
stromfrei zu machen, müssen Sie den Netzstecker
ziehen.
The printer includes an auxiliary 24 volt power jack for the vac-
uum system. This option enables you to provide temporary
power to the vacuum system to prevent ink from flowing from
the printheads, in the event of a power failure or if the printer
must be powered down for maintenance. The power supply pro-
vided in the printer accessory kit includes interchangeable
adapter plugs for international use.
To provide battery backup power to the vacuum system, connect
the 24 volt power supply from the auxiliary power jack into a
UPS (uninterruptable power supply) that you purchase sepa-
rately. To provide temporary power during maintenance, simply
plug the 24 volt power supply directly into a wall outlet (see
Appendix A, Technical Specifications, for detailed specifica-
tions).
Fig. 1-15. Auxiliary vacuum power