DisplayMaker Legacy 72S and 72SR - User Manual

1-18 Unpacking and Assembly
Note
Ensure that the drain tube is fully attached to the res-
ervoir with a “click.” Partial attachment will not
allow ink to drain into the reservoir, which will even-
tually cause the service station to overflow with
excess ink.
34. Connect the cable to the sensor on the excess ink reservoir
(see Fig. 1-11).
35. Connect the supply and takeup cable to the port on the side
of the electronics box (see Fig. 1-12).
As you look at the front of the printer, the port is located on
the left side of the electronics box, near two other cables
that area already connected to ports. Connect the cable
firmly to the port.
36. Remove the two Phillips head screws on the front of the vac-
uum/pressure system cover, and remove the cover.
Fig. 1-12. Connecting the supply & takeup cable
Supply & takeup cable