DisplayMaker Legacy 72SI and 98SI - Print Server and Driver Setup Guide

Selecting Server Options 1-7
Selecting Server
Options
The following server options are explained in this section:
◆ 600x300 Printing
◆ Configuring the Input Port (page 1-8)
◆ Attention Queue Jobs (page 1-13)
◆ Tiling (page 1-14)
For instructions on other server functions, refer to the System
Control User Guide.
600x300 Printing The resolution at which the printer prints is determined by the
resolution at which the print job was RIPed. If the job was RIPed
at 600x600 dpi, it will print at that resolution. If the job was
RIPed at 600x300 dpi, it will print at that resolution. There is no
resolution setting at the printer control panel, nor are any set-
tings required at the application that created the document.
The RIP resolution is configured at the Configure Port dialog
box (see “Configuring the Input Port” on page 1-8 for instruc-
tions).