DisplayMaker Legacy X-12+ - User Manual

B-6 Diagnostics
A-MS-3 - Media Too Far Left/Right Media is loaded too far to the left or
right.
Reload the media; align right edge to
reference mark.
A-MS-4 - Media Out There is no media loaded. Load media.
A-MS-5 - Media Too Narrow Media is not wide enough for print-
ing.
Load media that is at least 24 inches
wide.
A-MS-6 - Media Too Wide Media is too wide for printing. Use narrower media (page A-3).
W-MS-1 - Media Low Less than 10 feet (3 meters) of media
remains.
Load media or adjust Media Remain-
ing value at panel (page 3-26).
W-MS-2 - Non-Standard Media
Width
Media loaded may cause head strike. Continue printing or replace media.
W-MS-3 - Media End Not Detected
During Unload
The Unload function cannot find end
of media.
Cut media prior to Unload, or do not
use Unload.
(PC) Printing Calibrations
A-PC-1 - Too Many Jets Mapped Out Too many missing jets could be
replaced.
Prime/clean printheads (page 5-13),
or increase number of passes (page
3-7).
W-PC-1 - Printhead Removed -
Recalibrate
A printhead was repositioned. Run AutoSet (page 2-7).
W-PC-2 - Media Replaced -
Recalibrate
Media caliper may need to be remea-
sured.
Run AutoSet if media type was
changed (page 2-7).
W-PC-3 - Head Height Changed -
Recalibrate
Change in head height has invali-
dated calibration.
Run AutoSet (page 2-7).
W-PC-4 - AutoJet - Jets Not Mapped
Out
Not all missing jets could be
replaced.
Prime/clean printheads (page 5-3), or
increase number of passes (page 3-7).
(PD) Primer Door
A-PD-1 - Door Opened, Prime Not
Selected
The primer door is open. Close the primer door.
(PG) Purge
W-PG-1 - Pens Require Purge The printheads should be purged. Purge all printheads (page 5-14).
(SC) System Calibrations
W-SC-1 - Media Adv. Run Out Not
Calibrated
Calibration was reset or not per-
formed.
Calibrate media advance (page 4-4).
W-SC-3 - Media Thickness Sensor Not
Calibrated
Calibration was reset or not per-
formed.
Calibrate media sensor (page 2-17).
W-SC-4 - Head Height Not Calibrated Calibration was reset or not per-
formed.
Calibrate head height (page 2-17).
W-SC-5 - Printer Length Not Known Calibration was reset or not per-
formed.
Calibrate printer length by restarting
printer.
Table B-1. Actions and Warnings
Code, Message Cause What to Do