DisplayMaker Legacy 72SI and 98SI - Print Server and Driver Setup Guide

Selecting Server Options 1-11
To specify step-and-repeat settings for an image:
1. In the System Control interface, route a port to the Output
Hold queue, or pause the Standard port.
2. Print an image to the port that is routed to the Output
Hold queue or paused Standard port.
After the job has RIPed, it appears in the queue.
3. Open the queue, select a document, then double-click the
document listing to open the Document Details dialog
box.
The Document Details dialog box appears.
4. In the Details section, click the “Printing” radio button to
display the Step-and-Repeat properties.
The Step-and-Repeat properties appear similar to this example (if
they do not appear, then Step-and-Repeat is not supported on
the selected printer):
◆ Length - when you click the Length radio button, the
Step-and-Repeat properties become visible. In the length
Fig. 1-6. Step-and-Repeat settings