DisplayMaker Legacy 72S and 72SR - User Manual

2-18 Menu Tree
Menu This menu tree reflects version 2.32 of the embedded printer software.
Refer to the Release Notes for more recent versions.
(72S)=option visible only on DisplayMaker 72S.
(72SR)=option visible only on DisplayMaker 72SR.
* = option visible only in rigid sheet-fed mode.
Calibrate Printer
Auto Calibrations
Auto Bidi Calibration
Auto H2H Calibration
AutoJet Calibration
Full AutoSet
Manual Calibrations
Media Feed
Manual Bidi Registration
Manual X Head Registration
Manual Jet Mapping
Jet Status Lines
Default Registration Data
AutoTune
AutoRecover
Calibration Summary
AutoSet Summary
Log Head Registration Data
Log Jet Data
Configure for Profile Creation (72SR/98SX)
Printer Settings
Takeup Tension
Supply Tension (72S/SR)
Supply Out Detection (72SRU/98SX)
Heater Temp Settings
Platen Vacuum Control
Drying Delay
Excess Ink Sensor
Capping Station Sensor
Media Out Sensor (72SR/SRU/98SX)
Gutter Settings
Top Gutters
Side Gutters
Left Platen Gutter
Platen Gutter Spits
Margin Settings
Space Between Prints (roll-fed media)
Right and Left Margin
Leading Margin (72SR/SRU/98SX)
Trailing Margin (72SR/SRU/98SX)
Measure Media Type
Quality Check
Print Position
Stiff Roll-Fed Media Handling
Standby Wait
Expert/Novice Messages
Audible Alarm
Localization (was “Units”)
Units of Measure
Time Format
Date Format
Head Height
Service Station
Air Purge Type
Automatic Eject (72SR/SRU/98SX)
Idle Spits
Printer Name
Restore All Defaults
Maintenance
Access Printheads
Purge A Color
Print Jet-Out Lines
Print Media Skew Lines
Fill Service Station
Reset Reservoir Filters
Respool Media
Clean Grit Rollers
Capping Purge
Printheads Procedures
Cleaning Solvent Soak
Prep for Storage/Shipping
Load Ink In All Heads
Fill Heads with Solvent
Fill Heads with Ink
Empty Heads (Fill With Air)
Cyan Heads Maintenance
Service Printer
User Diagnostics
Printhead Jet Statistics
VideoNet Status
VideoNet Connection
Carriage Motion
Calibration
Vacuum Pressure
Warnings and Actions List
Error History
Log Error History
Enable On-Head System
Warnings & Actions
(Expert mode only)