DisplayMaker Legacy 72S and 72SR - User Manual

Unpacking and Assembly 1-11
Caution
When assembling the printer onto the stand, be
careful to avoid damaging the turnbuckles under-
neath the postheater by allowing them to strike the
stand legs. The turnbuckles are precisely adjusted at
the factory, and will clear the stand legs by less than
one inch (25 mm) during assembly. Damaging them
could result in misalignment of the media path.
WARNING
The printer is too heavy to be lifted safely by one
person. At least three persons are required to lift the
printer.
WARNUNG
Der Drucker ist zu schwer für eine Person. Mindes-
tens 3 Personen sind erforderlich um den Drucker
anzuheben.
20. Align the two pins on each stand leg with the holes in printer
(see Fig. 1-5).
Have a fourth person perform steps 20 and 21 while three
persons hold the printer.
Fig. 1-4. Lowering the printer onto the stand