DisplayMaker Legacy 72S and 72SR - User Manual

Unpacking and Assembly 1-9
13. Bias the stand legs outward at the top, then tighten the
screws firmly (see Fig. 1-2) but not all the way.
With your foot braced against the outside of the left caster
support, gently tug the top of the stand leg toward you,
while a second person tightens the screws. Repeat this pro-
cess with the right stand leg. This step is required to ensure
proper clearance for the media spools.
Note
Leave the threading strings inside the stand legs. You
will use them later to pull the ink drain tubes
through the legs.
14. If purchased, install the VOC plenum kit.
Refer to the instructions included with the kit.
Fig. 1-2. Bias the stand legs outward as shown
(angle exaggerated for clarity)