DisplayMaker Legacy 72S and 72SR - User Manual

Replace Ink Filters 5-19

4. Use a Phillips screwdriver to loosen the filter clamp.

See Fig. 5-12 for location.

5. Unscrew the hose connectors from filter.

See Fig. 5-12 for location.

6. Remove the old filter.

7. Install the new filter into the filter clamp.

The filter’s label has an arrow that indicates the direction of

flow. Install the filter with the arrow pointing up.

8. Tighten the filter clamp.

The filter should be secure, but do not overtighten the

screw.

9. Connect the hoses to the top and bottom of the filter, and

tighten the connectors.

10. Replace the reservoir.

11. Reconnect the tube to the reservoir, and tighten the

connector.

See Fig. 5-11 for location.

12. Reconnect the level sensor cable.

See Fig. 5-11 for location.

Fig. 5-12. Filter connections

Connector

Filter

Clamp