DisplayMaker Legacy 72S and 72SR - User Manual

5-18 Replace Ink Filters
Replace Ink Filters The control panel displays a Warning message on the control
panel when 20 liters of ink has passed through the filters.
Replace all five the filters as a set. Failure to replace the filters
when recommended will eventually cause the filters to clog and
prevent ink from reaching the printheads.
Have a paper towel ready to catch the small amount of ink or
cleaning solvent that will spill out of some of the tubes and the
filter itself as you disconnect them. The reservoir shelf is
designed to catch these spills for easier cleanup. You may also
want to wear protective gloves during this procedure.
1. Disconnect the tube from the ink or cleaning solvent reser-
voir.
Unscrew the tube connector and disconnect the tube. See
Fig. 5-11 for location.
2. Disconnect the level sensor cable from the reservoir.
Press down on the cable connector tab to release the
connector. See Fig. 5-11 for location.
3. Remove the reservoir from the shelf.
Fig. 5-11. Reservoir connections
Tube connector
Cable connector
Ink reservoir