DisplayMaker Legacy 72S and 72SR - User Manual

Set the Printhead and Camera Height 5-15
The control panel displays a message asking whether you
want to perform a bidirectional (bidi) calibration.
19. Press
" to perform a bidi calibration, or ( to continue.
20. Observe a Purge-n-Wipe cycle to ensure that the service sta-
tion wipers are centered and properly deflected during a
wipe.
◆ If the wipers are not centered, see “Calibrate the Service
Station” on page 5-16 for instructions.
◆ If the wipers do not touch the service station or are over-
deflected, see “Calibrate the Service Station” on page 5-
16 for instructions.