DisplayMaker Legacy 72UVX and 98UVX - User Manual

3-22 Unloading and Cutting Roll-Fed Media
Takeup Spool Pin Release To quickly unspool a large amount of media from the takeup
without damaging the takeup tension spring, you must first dis-
engage the spool from the takeup system.
The spool is normally engaged to the takeup motor with a tab at
the end of the spool. To disengage this tab, press the Unload key
to detension the supply & takeup system, then insert the takeup
spool pin release tool (supplied, part number 0504334) between
the spool and the bracket that holds the spool. This allows the
spool to spin independently from the takeup as you pull media
from it. When you are ready to begin printing, remove the pin
release tool and press the Load key on the control panel.
Fig. 3-9. Takeup spool pin release tool