DisplayMaker Legacy 72UVX and 98UVX - User Manual

Unloading and Cutting Roll-Fed Media 3-21
Unloading and
Cutting Roll-Fed
Media
1. Press the ) key on the Front Page screen to advance the
printed portion of the media past the platen.
2. On the Front Page screen of the control panel, press the
Unload key.
3. The control panel prompts you to press ! to unload media,
or ( to cancel.
4. Press ! to continue.
This detensions the supply and takeup spools.
5. Cut through the media with a utility knife below the platen.
As you cut the media from the printer, hold it to prevent it
from falling to the floor and possibly damaging it.
Note
If you scratch the platen while cutting media, be sure
to buff them out with a fine grade of sandpaper.
Scratches in the platen can cause media feed incon-
sistencies, which can lead to head strikes and arti-
facts in printed output.
6. Take the single print or the entire takeup spool with printed
output to your finishing area, and re-load the takeup system.
◆ To re-load the takeup, from the menu, press the Load
key on the control panel.