DisplayMaker Legacy 72UVX and 98UVX - User Manual

Operating Requirements 1-3
Environmental ◆ Make sure the room is well ventilated, with a temperature
and relative humidity within specifications (see “Specifica-
tions” on page A-2). Optimal printing and occurs within
these ranges.
◆ The high power UV light emitted by the curing lamps reacts
with oxygen and produces ozone. This formation tends to be
greatest during lamp start-up. The printer should be oper-
ated in a well-ventilated area to avoid minor effects such as
headaches, fatigue, and dryness of the upper respiratory
tract. Normal air movement will mix the ozone with fresh air,
causing it to revert back to oxygen.
◆ Store media and ink in an area with similar temperature and
humidity conditions as the printer.
◆ Locate the printer close enough to the print server (RIP) so
that they can be connected with the required cable.
◆ Locate the printer on a flat, level floor.
◆ Locate the printer where its normal operating noise will not
disturb quiet work areas.
◆ DO NOT install the printer near humidifiers, refrigerators,
fans, water faucets, heaters or similar equipment.
◆ DO NOT install the printer in areas where the temperature
changes abruptly, such as near air conditioners or in the path
of direct sunlight.
◆ DO NOT expose the printer to flames or dust.