DisplayMaker Legacy 72UVX and 98UVX - User Manual

5-16 Replace Ink Filters
Replace Ink Filters The control panel displays a Warning message on the control
panel when 20 liters of ink has passed through the filters.
Replace all four the filters as a set is recommended. Failure to
replace the filters will eventually cause the filters to clog and
prevent ink from reaching the printheads.
Have a paper towel ready to catch the small amount of ink that
will spill out of some of the tubes and the filter itself as you dis-
connect them. The drip shelf is designed to catch these spills for
easier cleanup. You may also want to wear protective gloves dur-
ing this procedure.
1. Disconnect the tube from the ink box.
2. Remove the ink box from the shelf.
3. Use a Phillips screwdriver to loosen the filter clamp.
See Fig. 5-9 for location.
4. Unscrew the hose connectors from filter.
See Fig. 5-9 for location.
5. Remove the old filter.
6. Install the new filter into the filter clamp.
Fig. 5-9. Filter connections
Connector
Connector
Filter
Clamp