DisplayMaker Legacy 72SI and 98SI - User Manual

2-18 Menu Tree
Menu This menu tree reflects version 3.11 of the embedded printer software.
Refer to the Release Notes for more recent versions.
Calibrate Printer
Media Feed
Manual Calibrations
Manual Bidi Registration
Manual X Head Registration
Manual Jet Mapping
Jet Status Lines
Default Registration Data
Auto Calibrations
Auto Bidi Calibration
Auto H2H Calibration
AutoJet Calibration
Full AutoSet
AutoTune
AutoRecover
Calibration Summary
AutoSet Summary
Log Head Registration Data
Log Jet Data
Configure for Profile Creation
Printer Settings
Takeup Tension
Supply Out Detection
Heater Temp Settings
Platen Vacuum Control
Drying Delay
Dryer Fans
Excess Ink Sensor
Capping Station Sensor
Media Out Sensor
Gutter Settings
Top Gutters
Side Gutters
Left Platen Gutter
Platen Gutter Spits
Margin Settings
Space Between Prints (roll-fed media)
Right and Left Margin
Leading Margin
Trailing Margin
Measure Media Type
Quality Check
Print Position
Stiff Roll-Fed Media Handling
Standby Wait
Expert/Novice Messages
Audible Alarm
Localization
Head Height
Service Station
Automatic Eject
Idle Spits
Low Ink Warning
Printer Name
Restore All Defaults
Maintenance
Access Printheads
Purge A Color
Print Jet-Out Lines
Print Media Skew Lines
Fill Service Station
Reset Reservoir Filters
Respool Media
Clean Grit Rollers
Capping Purge
Printheads Procedures
Cleaning Solvent Soak
Prep for Storage/Shipping
Load Ink In All Heads
Fill Heads with Solvent
Fill Heads with Ink
Empty Heads (Fill With Air)
Service Printer
Device Tests
Print Tests
Ink System Tests
Home Head
Home Service Wipers
Measure Media Width
Tension Supply & Takeup
Measure Platen Width
Zero Platen Width
Printhead Y Calibration
Image Sensor Calibration
Replace Printhead
Fill Replaced Printhead
Turn On/Off Heaters
Enhanced Drying
Print Info Pages
User Diagnostics
Printhead Jet Statistics
VideoNet Status
VideoNet Connection
Carriage Motion
Calibration
Vacuum Pressure
Warnings and Actions List
Error History
Log Error History
Warnings & Actions
(Expert mode only)
Print Menu Tree