DisplayMaker Legacy 72SI and 98SI - User Manual

2-6 Front Page
◆ Status — displays system parameters and the status of all
user-configurable options. Press the  and  keys to scroll
between pages. To change an option, go to the Printer Con-
figuration section of the menu.
◆ Print Mode — sets print quality mode. See “Selecting a Print
Mode” on page 3-4 for instructions.
◆ Advance Media — press the ) key to advance the media for-
ward. When you press and hold the ) key, the media moves
faster. Press the , key to reverse the media back onto the
supply spool. When you press and hold the , key, the media
moves faster. You can also press the Media Advance rocker
switch, mounted on the OHS near the postheater, to move
the media in either direction.
◆ Menu — displays the complete printer menu for access to
advanced configuration options (see “Menu” on page 2-9
for instructions).
◆ AutoJet — detects deflected and non-firing jets, and substi-
tutes working jets for them (in Production and Quality
modes).
◆ Prime Bars — fires all jets by drawing a set of lines called
prime bars. This is a good way to inspect and prepare the
jets for printing after they have been idle (see “Print Prime
Bars” on page 3-8). You can also print a similar pattern
called Print Jet-Out Lines, which shows which jets have been
detected and replaced by AutoJet (see page 2-14 for details).
Fig. 2-4. Status page 1