DisplayMaker Legacy 72S, 72SI and 98SI - Release Notes

- 11 -
DisplayMaker Gator Release Notes
Version 2.20
Release Notes
◆ Cyan Heads Maintenance — perform this new function every time the printer is idle for
24 hours, to keep the cyan printheads working. (If the printer is printing daily, the Cyan
Heads Maintenance is not necessary.) It performs two purges, then fills the heads with
cleaning solvent four times, then empties the heads, and then fills them with ink again.
(Menu > Maintenance > Printheads Procedures > Cyan Heads Maintenance) Follow
up with the procedure “Checking Jet Health” in Chapter 3 of the User Manual to keep all
jets are working.
◆ More accurate whitepoint readings — when creating color profiles using the printer’s
onboard camera, several whitepoint readings are taken across the width of the media.
◆ Measurement method tracked by Media Wizard — the Media Wizard now tracks
whether the media should be measured automatically by the printer or manually.
◆ Ink filter counter — Resetting the ink filter counter now resets all of the counts to zero,
not just the one(s) that are over the maintenance limit. The ink volumes filtered by
color are now shown on the printer Status pages (Front Page > Status).
◆ Print mode changes — when switching print modes, if a takeup/supply tension setting
changes from idle to tensioned, the control panel prompts you to reload the takeup/
supply, instead of displaying a Media Out message.
Version 2.15
Release Notes
Improved Features ◆ Added left-side gutter patterns to the manual Bidirectional and Head-to-Head calibra-
tions.
◆ When using sheet-fed media, the printer now stays online to accept another row of
prints when printing an N-UP job from the server.
◆ When a calibration pattern fails to print, the true reason rather than “cancelled by user”
is displayed on the control panel (if it was not cancelled by the user).
◆ “Left Only” print modes now appear as “Unidirectional” print modes throughout the
control panel interface.
◆ Roll-fed and cut-sheet media have different minimum right/left margins.
Version 2.10
Release Notes
New Features ◆ Edge-to-edge printing on rigid media — on rigid media, the printer can now print up
to the leading, right, and left edges when you set the margins to 0.
◆ Tape the platen under the left and right edges of the media to catch any over-
sprayed ink. Use a colored tape to allow the printer to find the media edges. A
piece of media printed with a solid color also works for this purpose.
◆ Use the head height gauge to set the printheads to the standard height over the
media. This will minimize ink overspray.
◆ From Menu > Printer Settings > Margin Settings > Right and Left Margin, Lead-
ing Margin, set the margins to 0. Optionally, you can set an Overprint distance to
print past the edge.
◆ If you set the Trailing Margin to 0 and want to print to the trailing edge, you must
attach a trailer of the same media to the trailing edge so the pinch rollers can feed
the media all the way past the print zone.