DisplayMaker Legacy X-12 - User Manual

3-34 Dryer Options
Dryer Options As the printed output advances past the dryer outlets, the dryer
blows air over the output to dry it. The print will continue to
advance until the trailing edge of the print has passed under the
dryer. The print remains stationary for twenty seconds, then will
reverse or advance according to the print mode. To cancel the
twenty-second delay, press the n (Cancel) key.
Drying Delay The printer’s relative humidity sensor enables the printer to
adjust the media advance speed to ensure adequate drying.
Higher relative humidity will result in slower printing. You can
adjust the amount of delay from the control panel; for instruc-
tions, see page 2-12.
Drying Rate There are two rates of media advance during post-print drying.
Select Standard for the fastest throughput. Select Same as print
speed to slow the advance if additional drying time is needed.
See Drying Rate on page 2-12.
Fans and Heater To turn off the dryer fans, select Configure Printer - Printer
Options - Dryer from the menu.
Caution
Output on polyester films can be streaked by the
dryer air flow. To avoid this, turn off the dryer fans
from the control panel.
Relative
Humidity Printer Action
0–29% Low humidity warning displayed, jets may drop out
and media may lift from the platen
30–59% Optimal, no warning or drying delay
60–79% High humidity warning displayed, media advance is
delayed automatically as humidity increases
> 80%
Action displayed, printing stops. User must specify a
manual drying delay to proceed with printing (see
Drying Delay on page 2-12)