DisplayMaker Legacy X-12 - User Manual

2-18 Menu
Prime Pens
Moves the carriage out of the service station home position so
that it can be accessed behind the access door for manual prim-
ing (for instructions, see “Manual Priming” on page 5-8).
Prime Bars
Prints a wide-swath version of the prime bars.
Disable Media Sensor
If the media sensor is malfunctioning, disable it to continue
printing. Note that with the media sensor disabled, the printer
will not be able to detect when there is no media in the printer.
Disable Latch Sensor
If the carriage latch sensor is defective, this function allows you
to disable the sensor until a replacement can be installed. Do
this only at the direction of MacDermid ColorSpan Technical
Services.
New Carriage
Select this option when installing a new carriage, to set the head
height to “uncalibrated.” After doing so, printing is not allowed
until the head height is calibrated (see Chapter 4, Calibrating the
Printer, for instructions).
Warnings & Actions When in Expert mode, active Warnings, Changes, and Actions
can be displayed by selecting Warnings & Actions from the
menu, since Warnings will not cause the ATTN icon will appear
in Expert mode. This option does not appear in Novice mode.
See “User Assistance” on page 2-3 for further information about
Actions and Warnings, and the table beginning on page B-5 for a
list of recovery procedures. See page 2-13 for a description of the
Expert/Novice Messages mode.
Load Takeup This option helps you to load media: it measures the width of
the media, checks for proper media positioning on the platen
(for good vacuum contact), asks the user to enter the amount
remaining on the supply roll, and asks the user to select a takeup
option. See “Loading Media” on page 3-26 for instructions.
You can also access this function from the Front Page screen,
under Load (see page 2-8).