DisplayMaker Legacy X-12 - User Manual

2-12 Menu
◆ Right and Left Margin — sets the amount of blank space
for the right and left margins, between 0 and 5 inches
(13 cm).
◆ Drying Settings — sets parameters for the operation of the
dryer:
◆ Drying Delay — select the printer’s preprogrammed
algorithm for slowing the print speed when the ambient
relative humidity is excessive, or specify a custom dry-
ing delay in seconds per print swath. A longer delay
allows the output to remain under the dryer longer,
which ensures adequate drying under higher ambient
relative humidity.
To increase the media advance speed, you can specify a
manual drying delay. If you specify a manual drying
delay interval that will be insufficient to dry the output,
the printer will display a warning message on the con-
trol panel. Be aware that if you override this warning
without increasing the drying delay, you should not use
the takeup system, and take care to remove output from
the printer before it reaches the floor, and store it flat
until it dries. Using the takeup to collect wet output, or
allowing wet output to pile on the floor, would likely
result in ruined prints.
◆ Drying Rate — sets the rate of media advance during
post-print drying. Select Standard for fastest through-
put. Select Same as print speed to slow the advance if
additional drying time is needed.
◆ Platen Vacuum Control — turns on the vacuum fans, then
allows you to raise or lower the speed of the vacuum fans.
Raise the speed if the media is rising off the platen, lower the
speed if the media is buckling or wrinkling.