DisplayMaker Legacy 72UVX and 98UVX - User Manual

5-8 Recover Missing Ink Jets
Note
Do not wipe the printheads repeatedly; this could
result in lost jets.
Caution
Purged printheads must be wiped before printing or
moving the carriage across the platen. Moving the
carriage with wet printheads will cause uncured
(wet) ink to drop onto the platen and louvers. The
ink will smoke if it contacts heated louvers.
Tip
If the printheads are not centered above the wiper,
perform a Wiping Position calibration (see “Calibrate
the Wiping Position” on page 5-14).
8. Repeat the previous step in positions
n, o, p, and q as
needed (see Fig. 5-5 on page 5-8).
9. Clean the wiper with a lint-free cloth, moistened with
SolaChrome UV Printhead Flush.
Do not use a paper towel, which could shed fibers that could
clog the inkjets.
10. The carriage moves out of the wiping station.
11. Close the wiping station cover.
12. The carraige moves back into the wiping station.
13 . P r i n t t h e Prime Bars.
◆ If all jets (indicated by a printed line) are working, the
printer is ready to print.
Fig. 5-5. Wiping the printheads
Wiper