DisplayMaker Legacy 72UVX and 98UVX - User Manual

3-40 Edge-to-Edge Printing
◆ During Load Media, the printer locates two points on
each of the leading, left, and right edges of the media.
The printer uses these data points, and assumes 90-
degree corners and parallel sides, to determine the skew
of the media. If the media is skewed enough that an
unprinted left or right edge may result, even with a mar-
gin of 0 and the amount of overprinting specified, the
control panel displays a message with the skew amount:
Correct the skew by nudging the trailing edge of the
media by the distance left or right as reported by the
control panel, without releasing the pinch rollers. Allow
the printer to measure the media again. Repeat until the
skew is within tolerance.
Note
LEFT and RIGHT are defined as if facing the front of
the printer: RIGHT is toward the control panel, LEFT
is toward the opposite end.
Tip
If you set the overprint distance to a smaller number,
there will be less skew tolerance before the printer
reports too much skew. If you set a larger overprint
distance, the printer will permit a greater amount of
media skew before displaying the error message.
Fig. 3-22. Skew message