DisplayMaker Legacy 72UVX and 98UVX - User Manual

Loading Rigid Media 3-27
Loading Rigid Media The printer has two media load states:
◆ Unloaded — the printer is ready to accept either roll-fed or
rigid cut-sheet media
◆ Loaded — the Media Wizard has stored parameters for the
currently-loaded cut-sheet media, allowing you to reload
multiple cut sheets without reentering the Media Wizard
Caution
Rigid synthetic media commonly used for inkjet
printing can build up a static charge, especially in
environments with low relative humidity. This charge
can pose an electrostatic discharge (ESD) hazard to
persons, the printer, and other equipment. It can be
safely discharged by draping a grounded chain or
tinsel over the top of the stack, or with the optional
ionizer bar (contact your reseller or MacDermid
ColorSpan to order).
Tip
If you are printing multiple copies of the same image
on rigid cut-sheet media, you can skip much of the
load process by using the Reload Media function for
the second and subsequent prints. See “Unloading
and Reloading Rigid Media” on page 3-35 for details.
For optimal results when printing on rigid cut-sheet media:
◆ Ensure that the printer has been correctly assembled and lev-
eled, and operates on a flat, stable floor.
◆ Ensure that the media input and output tables have been
correctly assembled, are level left-to-right, and are at the
same height as the printer platen.
◆ Use only flat, unwarped or damaged sheets, with parallel
opposite edges and 90
° corners.