DisplayMaker Legacy X-12+ - User Manual

Unpacking and Assembly 1-11
9. Gently tip the assembled stand on its back, and set it down
on top of the shipping supports as shown in Fig. 1-6.
10. Using the four silver Phillips head screws provided (two per
leg), attach the stand to printer module.
The silver screws are required to establish an electrical
ground connection between the printer and stand.
11. Press the caster locks down to prevent the printer from
rolling.
12. With the aid of one or more persons, carefully rotate the
assembled printer upright.
Be ready for the printer’s center of gravity to shift, so you
can tip the printer to its upright position in a controlled
manner.
13. Unlock the casters and roll the printer to its final location.
Then lock down the casters.
14. Locate the printer on a flat, level floor, with all four wheels of
the stand resting stationary on the floor. The printer must
remain stationary and level for proper ink flow and best print
quality.
15. Locate and connect the profiler docking station cable on the
left end of the printer, and connect it from the left-hand ink
tray to the port on the printer.
Fig. 1-6. Assemble the printer module and stand