DisplayMaker Legacy 72SI and 98SI - Print Server and Driver Setup Guide

Color Calibration 1-25
Be sure to place the eye of the calibrator on an area of the
color swatch that has uniform pattern reproduction. Avoid
placing the eye over any defects, blemishes, or ink inconsis-
tencies on the color swatch.
b. Press and hold the Calibrator base down until the print
server beeps, indicating that the reading has been taken.
The box moves to the next swatch on the screen as a beep
signals that you can take the next reading.
c. Repeat these readings with the next swatch until you
have measured all of the swatches.
To start over at any time during the calibration process, click
Cancel in the dialog box. The previous profiling informa-
tion is preserved and the calibration process is terminated.
If you take a white point reading after reading some or all
color values, all color values are removed from the screen,
and you must restart the reading of color values.
Be sure to take a reading for each color. If you make a mis-
take, click Cancel and start over.
d. When the values of all swatches are displayed and cor-
rect, the Save switch is enabled.
When all of the swatches have been read, a dialog box
appears that shows the calibration data for each swatch.
18 . G o t o st e p 34.
DTP41
19. Follow the prompts to feed the color swatch strips through
the reader, according to the instructions in the manufac-
turer’s user manual.
20. When you have read all of the strips, go to step 34.