User Guide

Control panel message Description Recommended action
alternates with
To continue touch OK
The supplies gauge will display the
consumption levels of print cartridges.
3. Open the right covers and then open
the ETB.
CAUTION The transfer belt
can be easily damaged.
4. Remove the specified print cartridge.
5. Install a new print cartridge.
6. Close the ETB and then close the right
covers.
7. Supplies ordering information is also
available from the embedded Web
server. See
Using the
embedded Web server on page 620 for
more information.
REPLACE FUSER KIT
For help press ?
The fuser kit has reached the end of its life.
Replace the fuser kit. Printing can continue
but print quality might be reduced.
1. Open the top cover.
2. Grasp the purple handles on the fuser
unit.
3. Remove the old fuser unit from the
MFP.
4. Install a new fuser unit and secure
with thumb screws.
5. Close the top cover.
6. Supplies ordering information is also
available from the embedded Web
server. See
Using the
embedded Web server on page 620 for
more information.
REPLACE FUSER KIT
For help press ?
alternates with
REPLACE FUSER KIT
To continue touch OK
The fuser is nearing the end of its useful life
and the REPLACE SUPPLIES setting in
the SYSTEM SETUP menu is set to STOP
AT LOW. Printing can continue.
1. Order the fuser kit.
2. To continue printing, touch OK.
3. To replace the fuser kit, perform the
following steps:
●
Open the top cover.
●
Grasp the purple handles on the
fuser unit.
●
Remove the old fuser unit from
the MFP.
●
Install the new fuser unit.
●
Close the top cover.
●
Supplies ordering information is
also available from the
embedded Web server. See
Using the embedded Web server
on page 620 for more information.
512 Chapter 7 Troubleshooting ENWW