User Guide

Control panel message Description Recommended action
output device. If it is flashing or amber, see
Accessory lights for the 3-bin mailbox and
stapler/stacker on page 519.
Receiving
upgrade
A firmware upgrade is in progress. Do not turn the MFP off until the MFP
returns to READY.
REINSTALL OUTPUT DEVICE The output-bin-detection switch, SW103,
has detected that no output device is
installed. WRONG SWITCH
Make sure the output bin, 3-bin mailbox, or
stapler/stacker is correctly installed on the
MFP.
Turn the MFP off. If you are using the
stapler/stacker or the 3-bin mailbox, make
sure that the cable is connected to the
MFP. Reattach the output bin, and then
turn the MFP on. Observe the LED on the
output device. If it is flashing or amber, see
Accessory lights for the 3-bin mailbox and
stapler/stacker on page 519.
REMOVE ALL
PRINT CARTRIDGES
To exit press Stop
The MFP is executing a component test
and the component selected is Belt Only.
Remove all print cartridges.
Remove at least one
print cartridge.
To exit press Stop
The MFP is executing a disable cartridge
check or component test where the
component selected is the cartridge motor.
Remove one print cartridge.
REPLACE <COLOR>
CARTRIDGE
The supplies gauge will display the
consumption levels of print cartridges.
The identified print cartridge has reached
the end of life and the COLOR SUPPLY
OUT setting in the SYSTEM SETUP menu
is set to STOP AT OUT. Printing cannot
continue until the print cartridge is replaced.
To hide this message and continue to use
fax and e-mail features, touch Ignore.
1. Order the appropriate print cartridge.
2. To continue, touch OK.
3. Open the right covers and then open
the ETB.
CAUTION The transfer belt
can be easily damaged.
4. Remove the specified print cartridge.
5. Install a new print cartridge.
6. Close the ETB and then close the right
covers.
7. Supplies ordering information is also
available from the embedded Web
server. See
Using the
embedded Web server on page 620 for
more information.
REPLACE <COLOR>
CARTRIDGE
The supplies gauge will display the
consumption levels of print cartridges.
The identified print cartridge has reached
the end of life and the COLOR SUPPLY
OUT setting in the SYSTEM SETUP menu
is set to STOP AT LOW. Printing can
continue.
1. Order the appropriate print cartridge.
2. To continue, touch OK.
ENWW Control panel messages 511