User Guide

Control panel message Description Recommended action
8. Repeat the previous steps as
necessary for each supply that needs
to be ordered.
9. Supplies ordering information is also
available from the embedded Web
server. See
Using the
embedded Web server on page 620 for
more information.
ORDER TRANSFER KIT
LESS THAN X PAGES
For help press ?
alternates with
READY
The transfer unit is near end of life.
Printing can continue.
1.
Press
to view help for the message.
2. Obtain the transfer kit part number
from help.
3. Order the transfer kit.
NOTE Supplies ordering
information is also available from
the embedded Web server. See
Using the embedded Web server
on page 620 for more information.
OUTPUT ACCESSORY BRIDGE
ATTACHED
The IPTU is attached. No action required.
OUTPUT ACCESSORY BRIDGE
DISCONNECTED
The IPTU is disconnected. Verify that the IPTU connection is secure. If
necessary, remove and then reinstall the
IPTU.
OUTPUT ACCESSORY BRIDGE
FAILURE
The IPTU has failed. Turn the MFP off, verify that the IPTU
connection is secure, and turn the MFP on.
If necessary, remove and then reinstall the
IPTU.
OUTPUT PAPER PATH OPEN The path between the MFP and the output
device is open and must be closed before
printing can continue.
1. If you have a 3-bin mailbox installed,
make sure the jam access door is
closed.
2. If you have a stapler/stacker installed,
make sure the staple cartridge is
snapped into position and that the
staple cartridge door is closed.
.
Password or name is incorrect. Please
enter correct login.
FAILURE
The user name or password was typed
incorrectly.
Retype the user name or password.
Paused
To return to Ready
press RESUME key
The MFP is paused, and there are no error
messages pending at the display. The I/O
continues receiving data until memory is full.
Press the Stop key.
Performing
PRINT/STOP TEST
The MFP is performing a print/stop test. No action necessary.
Performing A firmware upgrade is in process. Do not turn the MFP off until the MFP
returns to READY.
ENWW Control panel messages 507