User Guide

5. Close the staple cartridge cover, and slide the stapler/stacker into the MFP.
Replacing the ETB
Replace the ETB when a REPLACE TRANSFER KIT message appears on the product control panel
display.
1. Turn the MFP off.
2. Open the right upper and lower covers.
3. Lower the ETB by pulling the green handle at the top of the unit downward.
4. Press the small blue latches located on either side of the bottom of the ETB and lift the unit out
of the MFP.
5. Install the new ETB.
6. Close the right upper and lower covers.
7. Supplies ordering information is also available from the embedded Web server. See
Using the
embedded Web server on page 111 for more information.
Replacing the fuser
Replace the fuser when a REPLACE FUSER KIT message appears on the product control panel
display.
1. Turn the MFP off.
2. Open the right upper cover.
3. Grasp the purple handles on the fuser.
4. Remove the old fuser from the MFP.
5. Install the new fuser.
6. Close the right upper cover.
7. Supplies ordering information is also available from the embedded Web server. See
Parts and
supplies on page 43 for more information.
ENWW Replacing supplies 119