- Hewlett-Packard Color LaserJet User Guide

216 DIMM Installation EN
DIMM configuration
This printer supports up to 192 MB of memory. You can add additional
Random Access Memory (RAM) to this printer by installing Dual
Inline Memory Modules (DIMMs). The printer uses 168-pin,
non-parity, synchronous DRAM memory modules. Extended Data
Output (EDO) DIMMs are not supported.
You can install 64 or 128 MB DIMMs into either of the printer’s
available 168-pin DIMM slots.
CAUTION Do not attempt to remove the DIMM in slot #1 (see figure A-1). The
DIMM in slot #1 is part of the printer’s firmware. Removing it will affect
printer operation.
Figure A-1 Do not remove the DIMM in slot #1.