Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
18-16
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 18 Configuring Fibre Channel Routing Services and Protocols
Default Settings
You see the general VSAN attributes in the Information pane as shown in Figure 18-14.
Figure 18-14 General VSAN Attributes
Step 3
Double-click the Network Latency field and change the value.
Step 4 Click Apply Changes to save these changes, or click Undo Changes to discard any unsaved changes.
Default Settings
Table 18-2 lists the default settings for FSPF features.
Table 18-2 Default FSPF Settings
Parameters Default
FSPF Enabled on all E ports and TE ports.
SPF computation Dynamic.
SPF hold time 0.
Backbone region 0.
Acknowledgment interval (RxmtInterval) 5 seconds.
Refresh time (LSRefreshTime) 30 minutes.
Maximum age (MaxAge) 60 minutes.
Hello interval 20 seconds.
Dead interval 80 seconds.
Distribution tree information Derived from the principal switch (root node).
Routing table FSPF stores up to 16 equal cost paths to a given
destination.
Load balancing Based on destination ID and source ID on different, equal
cost paths.
In-order delivery Disabled.
Drop latency Disabled.