Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, April 2008)
1-26
Cisco MDS 9200 Series Hardware Installation Guide
OL-16188-01
Chapter 1 Product Overview
Services Modules
LEDs on IP Storage Services Module
Table 1-8 describes the LEDs for the IPS module.
32-Port Fibre Channel Storage Services Module
The 32-port Fibre Channel Storage Services Module (SSM) for the Cisco MDS 9000 Family supports
up to 32 Fibre Channel ports, provides distributed intelligent storage services, and supports future
storage services.
Note Cisco MDS 9200 Series switches running Cisco MDS SAN-OS Release 2.0(2b) or later support the
SSM.
Table 1-8 LEDs for the Cisco MDS 9000 Family IPS Modules
LED Status Description
Status Green All diagnostics pass. The module is operational (normal
initialization sequence).
Orange One of the following occurs or occurred:
• The module is booting or running diagnostics (normal
initialization sequence).
• The inlet air temperature of the system exceeded the
maximum system operating temperature limit (a minor
environmental warning). To ensure maximum product
life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red One of the following occurred:
• The diagnostic test failed. The module is not
operational because a fault occurred during the
initialization sequence.
• The inlet air temperature of the system exceeded the
safe operating temperature limits of the card (a major
environmental warning). The card shut down to prevent
permanent damage.
Link Solid
green
Link is up.
Flashing
green
Link is up (beacon used to identify port).
Solid
yellow
Link is disabled by software.
Flashing
yellow
A fault condition exists.
Off No link.