Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, April 2008)

1-24
Cisco MDS 9200 Series Hardware Installation Guide
OL-16188-01
Chapter 1 Product Overview
Services Modules
LEDs on the 14/2-Port Multiprotocol Services Module
Table 1-7 describes the LEDs for the MPS-14/2 modules.
IP Storage Services Modules
The 8-port and 4-port IP Storage services (IPS-8 and IPS-4) modules provide eight or four 1-Gigabit
Ethernet ports for iSCSI as well as FCIP over Gigabit Ethernet, and they support the intelligent features
available on other modules, including VSANs, security, and traffic management.
The IPS module ports support the iSCSI protocol, the FCIP protocol, or both protocols simultaneously.
For information about configuring the ports, see the Cisco MDS 9000 Family CLI Configuration Guide
and the Cisco MDS 9000 Family Fabric Manager Configuration Guide.
Table 1-7 LEDs for the Cisco MDS 9000 Family MPS-14/2 Modules
LED Status Description
Status Green All diagnostics pass. The module is operational (normal
initialization sequence).
Orange One of the following occurs or occurred:
• The module is booting or running diagnostics (normal
initialization sequence).
• The inlet air temperature of the system exceeded the
maximum system operating temperature limit (a minor
environmental warning). To ensure maximum product
life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red One of the following occurred:
• The diagnostic test failed. The module is not operational
because a fault occurred during the initialization
sequence.
• The inlet air temperature of the system exceeded the safe
operating temperature limits of the card (a major
environmental warning). The card shut down to prevent
permanent damage.
Speed On 2-Gbps mode.
Off 1-Gbps mode.
Flashing
green
Link is up (beacon used to identify port).
Link Solid
green
Link is up.
Solid
yellow
Link is disabled by software.
Flashing
yellow
A fault condition exists.
Off No link.