Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2(1) (OL-16599-01, March 2009)

Send comments to [e-mail]
2-16
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 2 Ethernet Commands
delay (interface)
delay (interface)
To set a delay value for an interface, use the delay command. To restore the default delay value, use the
no form of this command.
delay tens-of-microseconds
no delay
Syntax Description
Command Default 10 μsec
Command Modes Interface configuration mode
Command History
Examples The following example shows how to set a delay of 30,000 microseconds on an interface:
switch(config)# interface ethernet 1/1
switch(config-if)# delay 3000
Related Commands
tens-of-microseconds Specifies the throughput delay in tens of microseconds.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
show interface Displays the interface configuration information.