Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2) (OL-14116-10 C0, November 2008)

Send documentation comments to [e-mail]
43
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2)
OL-14116-10
Caveats
Workaround: This issue is resolved.
• CSCsr59106
Symptom: For two FCIP links on different modules but sharing a common DS3 pipe, the MDS
switch could not saturate the DS3 pipe. In another setup with no latency and min/max-bw configured
to 15mbps, the MDS FCIP shaper does not obey bandwidth rules and sends at a rate greater than
15mbps, which caused unnecessary drops in the network. This issue affects the MSM-18/4 module
and the MDS 9222i switch.
Workaround: This issue is resolved.
• CSCsr62565
Symptom: With the Cimserver enabled, a zone is created and a device-alias member is added to the
zone. Device-alias is in enhanced mode. While querying for ni/ei cisco_zonemembersettingdata, the
Cimserver fails.
Workaround: This issue is resolved.
• CSCsr70045
Symptom: An FCIP link with an underlying Ethernet interface set to a large MTU (9000 bytes) flaps
whenever data frames are sent. Control traffic (such as tape status check commands) are successful
and do not cause flaps. This issue only occurs on an MSM-18/4 modules.
Workaround: This issue is resolved.
• CSCsr71466
Symptom: A CFS de-register message is not sent when IVR is disabled.
Workaround: This issue is resolved.
• CSCsr79043
Symptom: The entries for all configurations are not removed from pss when a VSAN is deleted.
Workaround: This issue is resolved.
• CSCsu03045
Symptom: A module gets stuck in the upgrading state if the LCM gets an error.
Workaround: This issue is resolved.
• CSCsu31909
Symptom: A failure in the internal software on the MSM-18/4 module causes an FCIP link in the
PortChannel to drop.
Workaround: This issue is resolved.
• CSCsu44137
Symptom: A downgrade from NX-OS 4.1(1b) to SAN-OS 3.3(1c) is not supported on switches
when FC-Redirect based applications like DMM and SME are configured in the fabric, if either of
the following conditions are satisfied:
– A target for which FC-Redirect is configured is connected locally, and there are Generation 1
modules with ISLs configured in the switch.
– A host, for which FC-redirect is configured, is connected locally on a Generation 1 module.
In such cases, remove the application configuration for such targets and hosts before proceeding
with the downgrade.
Workaround: This issue is resolved.