Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, April 2008)

Contents
iv
Cisco MDS 9200 Series Hardware Installation Guide
OL-16188-01
18/4-Port Multiservice Module 1-19
18/4-Port Multiservice Federal Information Processing Standards Module 1-19
LEDs on the 18/4-Port Multiservice Module 1-20
14/2-Port Multiprotocol Services Module 1-21
LEDs on the 14/2-Port Multiprotocol Services Module 1-22
IP Storage Services Modules 1-23
LEDs on IP Storage Services Module 1-24
32-Port Fibre Channel Storage Services Module 1-25
LEDs on the Storage Services Module 1-26
32-Port Fibre Channel Advanced Services Module 1-27
LEDs on the Fibre Channel Advanced Services Module 1-28
Caching Services Module 1-29
LEDs on the Caching Services Module 1-31
Power Supplies 1-32
Fan Module 1-33
Supported Transceivers 1-33
X2 Fibre Channel Transceivers 1-34
Fibre Channel SFP Transceivers 1-34
Combination Fibre Channel/Gigabit Ethernet SFP Transceivers 1-34
CWDM Combination Fibre Channel/Gigabit Ethernet SFP Transceivers 1-35
Gigabit Ethernet SFP Transceivers 1-35
DWDM Fibre Channel SFP Transceivers 1-35
CHAPTER 2 Installing the Cisco MDS 9200 Series 2-1
Preinstallation 2-2
Installation Options 2-2
Installation Guidelines 2-3
Required Equipment 2-4
Unpacking and Inspecting the Switch 2-4
Installing the Chassis in a Cabinet or Rack 2-5
Installing the Switch in a Cabinet with Insufficient Front Clearance 2-11
Installing Front Rack-Mount Brackets for Cabinets with 26 Inches or Greater of Rail Spacings 2-12
Installing Front Rack-Mount Brackets for Cabinets with Less Than 26 Inches of Rail Spacings 2-14
Installing the Cisco MDS 9200 Series Rear-Facing into Cabinet 2-16
System Grounding 2-19
Proper Grounding Practices 2-19
Preventing Electrostatic Discharge Damage 2-21
Establishing the System Ground 2-23
Required Tools and Equipment 2-23