Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, April 2008)

1-20
Cisco MDS 9200 Series Hardware Installation Guide
OL-16188-01
Chapter 1 Product Overview
Services Modules
Services Modules
The Cisco MDS 9200 Series supports the following hot-swappable services modules:
• 1 8/4-Port Multiservice Module
• 18/4-Port Multiservice Federal Information Processing Standards Module
• 14/2-Port Multiprotocol Services Module
• IP Storage Services Modules
• 32-Port Fibre Channel Storage Services Module
• 32-Port Fibre Channel Advanced Services Module
• Caching Services Module
The Cisco MDS 9200 Series supports one hot-swappable switching or services module in addition to the
integrated module that is part of the supervisor module. Each module has temperature sensors and an
EEPROM that stores serial number and model number information.
Note The internal bootflash installed on the modules are not field-replaceable units. Do not remove or replace
internal bootflash on the modules. You cannot modify the factory installed bootflash.
18/4-Port Multiservice Module
The Cisco MDS 9000 Family 18/4-port Multiservice (MSM-18/4) module provides 18 autosensing
1-, 2-, and 4-Gbps Fibre Channel ports and four Gigabit Ethernet IP services ports. The MSM-18/4
module provides multiprotocol capabilities such as Fibre Channel, Fibre Channel over IP (FCIP), Small
Computer System Interface over IP (iSCSI), IBM Fiber Connectivity (FICON), and FICON Control Unit
Port (CUP) management.
The MSM-18/4 module provides 18 4-Gbps Fibre Channel interfaces for high-performance SAN and
mainframe connectivity and four Gigabit Ethernet ports for FCIP and iSCSI storage services. Individual
ports can be configured with hot-swappable short wavelength, long wavelength, extended-reach, coarse
wavelength-division multiplexing (CWDM) or dense wavelength-division multiplexing (DWDM) Small
Form-Factor Pluggables (SFPs) for connectivity up to 125 miles (200 km).
The MSM-18/4 module can minimize latency for disk and tape through FCIP write acceleration and
FCIP tape write and read acceleration. The MSM-18/4 module provides up to 16 virtual Inter-Switch
Link (ISL) connections on the four 1-Gigabit Ethernet ports through tunneling, and provides up to 4095
buffer-to-buffer credits that can be assigned to a single Fibre Channel port.
The MSM-18/4 supports hardware-based encryption and it is required to run the Storage Media
Encryption (SME), which is a part of the Cisco SAN-OS. For more information on SME, see the Cisco
MDS Storage Media Encryption Guide.
The MSM-18/4 supports SAN extension over IP and is compatible with current SAN extension products,
such as, MPS-14/2, 9216i, and IPS. The MSM-18/4 provides an integrated next generation 4-Gbps FC
platform for SAN extension. The MSM-18/4 module supports Internet Protocol version 6 (IPv6) as
mandated by the U.S. Department of Defense (DoD), Japan, and China. The IPv6 support is provided
for FCIP, iSCSI, and management traffic routed in-band and out-of-band.
The MSM-18/4 module provides intelligent diagnostics, protocol decoding, and network analysis tools
wit h the integrated Call Home capability.