Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide (OL-7765-06, November 2007)

Send documentation comments to [e-mail]
2-7
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
OL-7765-05
Chapter 2 Initial Switch Configuration
Using the Switch Setup Utility
Would you like to enter the basic configuration dialog (yes/no): yes
The switch setup utility guides you through the basic configuration process. Press Ctrl-C at any prompt
to end the configuration process.
Step 6 Enter no (no is the default) to not create any additional accounts.
Create another login account (yes/no) [n]: no
Step 7 Enter no (no is the default) to not configure any read-only SNMP community strings.
Configure read-only SNMP community string (yes/no) [n]: no
Step 8 Enter no (no is the default) to not configure any read-write SNMP community strings.
Configure read-write SNMP community string (yes/no) [n]: no
Step 9 Enter a name for the switch.
Note The switch name is limited to 32 alphanumeric characters. The default is switch.
Enter the switch name: switch_name
Step 10 Enter yes (yes is the default) to configure the out-of-band management configuration.
Continue with Out-of-band (mgmt0) management configuration? (yes/no) [y]: yes
a. Enter the IP address for the mgmt0 interface.
Mgmt0 IP address : mgmt_IP_address
b. Enter the netmask for the mgmt0 interface in the xxx.xxx.xxx.xxx format.
Mgmt0 IP netmask : xxx.xxx.xxx.xxx
Step 11 Enter yes (yes is the default) to configure the default gateway (recommended).
Configure the default-gateway: (yes/no) [y]: yes
Step 12 Enter the default gateway IP address.
IP address of the default-gateway: default_gateway
Step 13 Enter no (no is the default) to configure advanced IP options such as in-band management, static routes,
default network, DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: no
Step 14 Enter yes (yes is the default) to enable Telnet service.
Enable the telnet service? (yes/no) [y]: yes
Step 15 Enter no (no is the default) to not enable the SSH service.
Enable the ssh service? (yes/no) [n]: no
Step 16 Enter no (no is the default) to not configure the NTP server.
Configure the ntp server? (yes/no) [n]: no
Step 17 Enter noshut (shut is the default) to configure the default switch port interface to the noshut state.
Configure default switchport interface state (shut/noshut) [shut]: noshut