DCFM Enterprise User Manual (53-1001775-01, June 2010)

110 DCFM Enterprise User Manual
53-1001775-01
Editing the Brocade International or IBM call home center
4
FIGURE 49 Configure Call Home Center dialog box (Brocade International or IBM option)
4. Make sure the call home center type you selected displays in the Call Home Centers list.
5. Select Enable to enable this call home center.
6. Set the time interval at which to check the call home center by selecting the Set the heartbeat
interval at ___ days (1-28) check box and entering the interval in the field.
7. Enter the time out interval (default is 60 seconds) in the Time Out field.
8. Enter the retry interval (default is 10 seconds) in the Retry Interval field.
9. Enter the maximum number of retries (default is 3) in the Maximum Retries field.
10. Enter the primary phone number or extension of the call home center in the Call Home Center -
Primary Connection field.
11. Enter the backup phone number or extension of the call home center in the Call Home Center -
Backup Connection field.
12. Enter the phone number or extension of the local server in the Local Server - Phone Number
field.
13. Enter the identification number of the local server in the Local Server - Server ID field.
14. Click Send Test to test the phone number.
The selected call home center must be enabled to test the phone number.
A faked event is generated and sent to the selected call home center. You must contact the call
home center to verify that the event was received and in the correct format.
15. Click OK.
The Call Home dialog box displays with the call home center you edited highlighted in the Call
Home Centers table.
16. Click OK to close the Call Home dialog box.