Brocade Network Advisor Migration Guide v11.1x (53-1002321-01, May 2011)

58 of 82 Brocade Network Advisor Migration Guide
53-1002321-01
Network Advisor migration
9. Complete the following steps on the Server Configuration screen.
FIGURE 22 Server Configuration screen
a. Enable SSL by selecting the SSL Enabled check box (default is not selected).
b. Enter a port number in the Web Server Port # field (default is 443 if SSL Enabled is selected; otherwise, the
default is 80).
c. Enter a port number in the Database Port # field (default is 5432).
d. Enter a port number in the Starting Port # field (default is 24600).
NOTE
The server requires 16 consecutive free ports beginning with the starting port number.
e. Enter a port number in the Syslog Port # field (default is 514).
NOTE
If the default syslog port number is already in use, you will not receive any syslog messages from the device.
To find and stop the process currently running on the default Syslog port number, refer to “Syslog
troubleshooting” on page 80.
f. Enter a port number in the SNMP Port # field (default is 162).
g. Click Next.
If you enter a syslog port number already in use, a message displays. Click No on the message to remain on
the Server Configuration screen and edit the syslog port number. Click Yes to close the message and
continue with step 12.
If you enter a port number already in use, a warning displays next to the associated port number field. Edit
that port number and click Next.