Brocade Fabric OS Message Reference Supporting Fabric OS v6.0.0 (53-1000600-01, October 2007)

404 Fabric OS Message Reference
53-1000600-01
SEC-1155
66
SEC-1155
Message <timestamp>, [SEC-1155], <sequence-number>,, INFO, <system-name>, PID change
failed: <Reason> <defined status> <active status>.
Probable Cause Indicates that either the defined or active policy was too large after modifying the index/area ID.
The status values can be either defined, active, or both. A negative value means that a policy set
was failed by the daemon.
Recommended
Action
Reduce the size of the specified policy database.
Severity INFO
SEC-1156
Message <timestamp>, [SEC-1156], <sequence-number>,, INFO, <system-name>, Change failed:
<Reason> <defined status> <active status>.
Probable Cause Indicates that the security daemon is busy. The status values can be either defined, active, or both.
A negative value means that a policy set was failed by the daemon.
Recommended
Action
For the first reject, wait a few minutes and then resubmit the transaction. Fabric-wide commands
might take a few minutes to propagate throughout the fabric. Make sure to wait a few minutes
between executing commands so that your commands do not overlap in the fabric.
Severity INFO
SEC-1157
Message <timestamp>, [SEC-1157], <sequence-number>,, INFO, <system-name>, PID Change
failed: <Reason> <defined status> <active status>.
Probable Cause Indicates that the provisioning resources for a security policy failed due to low memory or internal
error. The status values can be either defined, active, or both. A negative value means that a policy
set was failed by the daemon.
Recommended
Action
Retry the failed command.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity INFO