Brocade Web Tools Administrator's Guide v6.1.0 (53-1000606-02, June 2008)

Web Tools Administrator’s Guide 35
53-1000606-02
Configuring a switch
3
4. Select a slot number from the drop-down list.
5. Enter the IP address, subnet mask, and Gateway IP address.
6. Select a type from the drop-down list.
7. Cli ck Add to add the new entry to the table.
When you click the Add button, the values remain in the fields.
The Clear Gateway and Clear IP buttons are available for clearing fields in the table.
To delete a configuration, select a row in the table and click the Delete button.
8. Click the Apply button to save the values currently shown in the table to the switch or click
Cancel to close the dialog box without saving any of your changes.
To update the switch with your changes, you must update the table using the Add and Delete
buttons, and then click Apply.
Viewing IP addresses
If you want to view the IP addresses configured on the switch for the currently populated slots, use
the Show IP Address button.
1. Open the Switch Administration window as described on page 31.
2. Click the Blade tab.
3. Click the Show IP Address button.
FIGURE 19 Show IP Address dialog box
4. Scroll through the list to view all the information.
5. When you are done, click Close.
Configuring a switch
Use the Switch tab of the Switch Administration window to perform basic switch configuration.
Figure 16 on page 30 shows an example of the Switch tab.