Manualshelf

Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

ManualsBrandsHP ManualsStorageBrocade 4Gb SAN Switch w/ Power Pack
301302303304305306307308309310
Fabric OS Message Reference 251
53-1001157-01
FW-1196
35
FW-1196
Message <timestamp>, [FW-1196], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, value has changed(High=<High value>, Low=<Low value>). Current value is
<Value> <Unit>.
Probable Cause Indicates that the number of link resets that the port experiences has changed. Link resets occur
due to link timeout errors that indicate no frame activity at all.
Recommended
Action
Check both ends of your cable connection. Verify if the cable and small form-factor pluggables
(SFPs) are faulty.
Severity INFO
FW-1197
Message <timestamp>, [FW-1197], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, is below low boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the number of link resets that the port experiences has fallen below the low
boundary. Link resets occur due to link timeout errors that indicate no frame activity at all.
Recommended
Action
Respond to this message as is appropriate to the particular policy of the end-user installation. A low
number of link resets means that the switch is functioning normally.
Severity INFO
FW-1198
Message <timestamp>, [FW-1198], <sequence-number>,, WARNING, <system-name>, <Port Name>,
<Label>, is above high boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the number of link resets that the port experiences has risen above the high
boundary. Link resets occur due to link timeout errors that indicate no frame activity at all. Both
physical and hardware problems can cause link resets to increase.
Recommended
Action
Check both ends of your cable connection. Verify if the cable and small form-factor pluggables
(SFPs) are faulty.
Severity WARNING
FW-1198
Message <timestamp>, [FW-1198], <sequence-number>,, WARNING, <system-name>, <Port Name>,
<Label>, is between high and low boundaries (High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.