Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

228 Fabric OS Message Reference
53-1001157-01
FW-1044
35
FW-1044
Message <timestamp>, [FW-1044], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the transmit power value of the small form-factor pluggable (SFP) has changed from
a value outside of the acceptable range to a value within the acceptable range. The transmit
performance area measures the amount of outgoing laser to help you determine if the SFP is in
good working condition or not. If the counter often exceeds the threshold, the SFP is deteriorating.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1045
Message <timestamp>, [FW-1045], <sequence-number>,, INFO, <system-name>, <Label>, value
has changed(High=<High value>, Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has changed. If the
supplied voltage of the SFP transceiver is outside of the normal range, this might indicate a
hardware failure.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation. Frequent messages indicate that you must replace the SFP.
Severity INFO
FW-1046
Message <timestamp>, [FW-1046], <sequence-number>,, WARNING, <system-name>, <Label>, is
below low boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has fallen below the low
boundary.
Recommended
Action
Verify that your optical components are clean and function properly. Replace deteriorating cables or
SFPs. Check for damage from heat or age.
Severity WARNING
FW-1047
Message <timestamp>, [FW-1047], <sequence-number>,, WARNING, <system-name>, <Label>, is
above high boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.