Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 39
53-1000600-02
AUTH-1031
3
Probable Cause Indicates the receiving payload does not have valid message code for a particular authentication
phase.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1031
Message <timestamp>, [AUTH-1031], <sequence-number>,, ERROR, <system-name>, Failed to
retrieve secret value: port
<port number>.
Probable Cause Indicates that the secret value was not set properly for the authenticated entity.
Recommended
Action
Reset the secret value by using secAuthSecret command.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
Severity ERROR
AUTH-1032
Message <timestamp>, [AUTH-1032], <sequence-number>,, ERROR, <system-name>, Failed to
generate <data type> for <message payload> payload: length <data length>, error
code <error code>, port <port number>.
Probable Cause Indicates that the authentication process failed to generate specific data (that is, challenge, nonce,
or response data) for an authentication payload. This usually relates to internal failure.
A nonce is a single-use, usually random value used in authentication protocols to prevent replay
attacks.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1033
Message <timestamp>, [AUTH-1033], <sequence-number>,, ERROR, <system-name>, Disable port
<port number> due to unauthorized switch <switch WWN value>.