Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 369
53-1000600-02
SEC-1026
66
SEC-1026
Message <timestamp>, [SEC-1026], <sequence-number>,, ERROR, <system-name>, Invalid format
or character in switch member
<switch member ID>.
Probable Cause Indicates that a corruption occurred during the distribution of the security database. This can occur
only when the primary fabric configurations server (FCS) distributes the security database to the
other switches in the fabric, then local validation finds the error in the security database. This is a
rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1028
Message <timestamp>, [SEC-1028], <sequence-number>,, ERROR, <system-name>, No name is
specified.
Probable Cause Indicates that a corruption occurred during the distribution of the security database. This can occur
only when the primary fabric configurations server (FCS) distributes the security database to the
other switches in the fabric, then local validation finds the error in the security database. This is a
rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1029
Message <timestamp>, [SEC-1029], <sequence-number>,, ERROR, <system-name>, Invalid
character in
<policy name>.
Probable Cause Indicates that a corruption occurred during the distribution of the security database. This can occur
only when the primary fabric configurations server (FCS) distributes the security database to the
other switches in the fabric, then local validation finds the error in the security database. This is a
rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR