Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 255
53-1000600-02
FW-1403
30
FW-1403
Message <timestamp>, [FW-1403], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the flash usage percentage has changed from a value outside of the acceptable
range to a value within the acceptable range. Flash increases and decreases slightly with normal
operation of the switch. Excessive permanent increases can lead to future problems.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1424
Message <timestamp>, [FW-1424], <sequence-number>,, WARNING, <system-name>, Switch status
changed from <Previous state> to <Current state>.
Probable Cause Indicates that the switch status is not in a healthy state. This occurred because of a policy violation.
Recommended
Action
Run the switchStatusShow command to determine the policy violation.
Severity WARNING
FW-1425
Message <timestamp>, [FW-1425], <sequence-number>,, INFO, <system-name>, Switch status
changed from
<Bad state> to HEALTHY.
Probable Cause Indicates that the switch status has changed to a healthy state. This occurred because a policy is
no longer violated.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1426
Message <timestamp>, [FW-1426], <sequence-number>,, WARNING, <system-name>, Switch status
change contributing factor Power supply: <Number Bad> bad, <Number Missing>
absent.
Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of
faulty or missing power supplies is greater than or equal to the policy set by the
switchStatusPolicySet command.