Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 187
53-1000600-02
Chapter
29
FSSM System Messages
FSSM-1002
Message <timestamp>, [FSSM-1002], <sequence-number>,, INFO, <system-name>, HA State is in
sync.
Probable Cause Indicates that the high availability (HA) state for the active control processor (CP) is in
synchronization with the HA state of the standby CP. If the standby CP is healthy, then a failover is
nondisruptive. For more information on the haFailover command, refer to the Fabric OS Command
Reference.
Recommended
Action
No action is required.
Severity INFO
FSSM-1003
Message <timestamp>, [FSSM-1003], <sequence-number>,, WARNING, <system-name>, HA State
out of sync.
Probable Cause Indicates that the high availability (HA) state for the active control processor (CP) is out of
synchronization with the HA state of the standby CP. If the active CP failover occurs when the HA
state is out of sync, the failover is disruptive.
Recommended
Action
If this message was logged as a result of a user-initiated action (such as running the switchReboot
command), then no action is required.
Otherwise, issue the haSyncStart command on the active CP and try resynchronizing the HA state.
If the HA state does not become synchronized, run the haDump command to diagnose the
problem.
If the problem persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
FSSM-1004
Message <timestamp>, [FSSM-1004], <sequence-number>,, INFO, <system-name>, Incompatible
software version in HA synchronization.