Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 161
53-1000600-02
FICN-1045
23
Probable Cause Protocol errors in emulation in the CU or network errors can cause Selective Reset.
Recommended
Action
If this was an unexpected event, please contact your vendor's customer support for assistance.
Severity ERROR
FICN-1045
Message <timestamp>, [FICN-1045], <sequence-number>,, WARNING, <system-name>,
HostTapeIng:FICON Purge received:Path=<FICON PATH>.
Probable Cause Purge path received from the locally connected FICON channel. This is performed during the path
recovery.
Recommended
Action
If this was an unexpected event, please contact your vendor's customer support for assistance.
Severity WARNING
FICN-1046
Message <timestamp>, [FICN-1046], <sequence-number>,, WARNING, <system-name>,
HostTapeIng:LRJ received on Path=<FICON PATH> lastCmds=0x<Last 4 commands
received from the channel for this device> lastStatus=0x<Last 4 status values
presented to the channel for this device> treating as system reset event.
Probable Cause An LRJ from a FICON channel indicates that the channel believes that it no longer has a path
established to the CU.
Recommended
Action
This is normally an unexpected event, please contact your vendor's customer support for
assistance.
Severity WARNING
FICN-1047
Message <timestamp>, [FICN-1047], <sequence-number>,, ERROR, <system-name>,
fcFicSetEmulation:Path=<FICON PATH> FDCB Not Idle state=0x<Current emulation
state of the FICON device> prevState=0x<Previous emulation state of the FICON
device> set to state=0x<The new state to which the device is transitioning>.
Probable Cause This is an internal emulation error and should not be encountered.
Recommended
Action
This is an unexpected event, please contact your vendor's customer support for assistance.
Severity ERROR